| Product
Info---Water Based Coating |
|
|
| AQUAPACK
XG 4336- High Gloss Packaging Coating |
| Description |
|
Aquapack
XG uses special surface additives to give the outstanding
rub resistance that packaging printers require. It gives extra
high gloss, excellent rub resistance, rapid drying, and good
block resistance
Directions
Use Aquapack XG as received, or carefully add
1:1 mix of IPA and water to reduce viscosity to the desired
level. The recommended temperature for application is 68 to
75℉. Adjust the warm air and lamp in the dryer to give the
correct load temperatures. Use warm water or mild ammonia
solution to clean coating equipment.
|
|
| AQUAPACK FS 4763 High
Gloss Packaging Coating |
|
|
DESCRIPTION:
AQUAPACK FS gives
packaging printers high gloss and high humidity block resistance.
The polymer system was selected to give the lowest possible odor
coupled with fast drying. AQUAPACK FS can be glued and foil stamped
but test first before using.
DIRECTIONS:
Use AQUAPACK FS as received, or carefully add water or a 1:1 mix
of IPA and water to reduce
viscosity to the desired level. The recommended temperature for
application is 68 to 75°F. Adjust the warm air and lamps in the
dryer to give the correct load temperatures. Use warm water or mild
ammonia solution to clean coating equipment.
|
| AQUAPACK
MNUV-2 4408- High Gloss Packaging Coating |
| Description: |
| Aquapack
MNUV-2 uses special surface additives to give the outstanding rub
resistance that packaging printers require. It gives extra high gloss,
excellent rub resistance, rapid drying, and good block resistance. |
| Directions: |
| Use
Aquapack MNUV-2 as received, or carefully add water Sparingly to reduce
viscosity to the desired level. The recommended temperature for application
is 68 to 75℉. Adjust the warm air and lamp in the dryer to give the
correct load temperatures. Use warm water or mild ammonia solution
to clean coating equipment. |
| |
| AQUACOAT
SATIN 4165 - Medium Gloss Coating |
| Description: |
| Aquacoat
Satin offers the a combination of smooth lay and reduced gloss. This
Product Introduction is formulated to be easy to run and free typical
coating defects seen in matte coating |
|
| Directions:
|
| Stir
before using, because the "flatting" agent may be settle with time.
Use Aquacoat Satin as received, or carefully add 1:1 mix of IPA and
water to reduce viscosity to the desired level. The recommended temperature
for application is 68 to 75℉. Adjust the warm air and lamp in the
dryer to give the correct load temperatures. Use warm water or mild
ammonia solution to clean coating equipment |
|
| AQUACOAT
DULL 4164- Low Gloss Coating |
| Description: |
| Aquacoat
Dull offers the a combination of smooth lay and reduced gloss. This
is formulated to be easy to run and free from typical coating defects
seen in low gloss coatings. |
| Directions:
|
Stir
before using, because the "flatting" agent may be settle with
time.
Use Aquacoat Satin as received, or carefully add 1:1 mix of IPA
and water to reduce viscosity to the desired level. The recommended
temperature for application is 68 to 75℉. Adjust the warm air
and lamp in the dryer to give the correct load temperatures. Use
warm water or mild ammonia solution to clean coating equipment.
|
